![]() A good signal is always higher than -75 dBm. Signal strength: This is the power of the received signal. If someone generates hard network traffic, this value will be high so you can detect it easily. Example: 433 Mpbs.ĪP latency: This is the latency time of your access point (router) in ms. ![]() In a wireless network, the link speed is always higher than the real achievable speed. The current value of link speed depends on the distance from the AP, the signal strength, supported protocols by the AP and your mobile. Link speed: This is the theoretical data rate. Possible WDS (expanded) network: In WiFi Network Analyzer app, this message shows that it found a network that seems to be an expanded network of the connected network. Using WDS you can extend the range of your wireless network. WDS (expanded) network: WDS allows a wireless network to be expanded using multiple access points without the traditional requirement for a wired backbone to link them. Possible guest network: in WiFi Network Analyzer app, this message shows that it found a network that seems to be a guest network of the connected network. The AP has dual SSIDs, dual security and the guest network is isolated from other networks. Guest network: Sharing your wifi with “guests”. In the 2.4 GHz band, 1, 6 and 11 are the only non-overlapping channels. Overlapping channel: the networks operate on close channels can cause interference on each other network. The most common is the 2.4 GHz (2412-2484 MHz), or the 5 GHz (4980-5825 MHz).Ĭhannel: Each frequency range is sub-divided into channels with a center frequency and bandwidth, analogous to the way radio and TV broadcast bands are sub-divided. Example: 192.168.0.1įrequency: All wifi networks operate on a special frequency. IP address: An Internet Protocol address (IP address) is a numerical label assigned to each device (e.g., computer, mobile phones) participating in a computer network that uses the Internet Protocol for communication. There can be several APs on the same network (same SSID) with different BSSIDs. MAC address: A media access control address (MAC address), also called physical address, is a unique identifier assigned to network interfaces for communications on the physical network segment. For example, it can be open (anybody can attach) or encrypted (with different encryption strength like WEP, WPA, WPA2) or even authenticated (username:password). A device that allows wireless devices to connect to a wired network using Wi-Fi, or related standards.ĪP capabilities: This is the security level of the AP. Example: my-networkĪccess point(AP): Generally, this is your router. SSID is a case sensitive, max 32 alphanumeric character unique identifier. SSID: This is the name of a wireless network. Using my laptop, I could reach the 40 MB/s transfer rate via samba, but my phone could only transfer with 7 MB/s. Then I tested the same on my mobile (LG G4) with my WiFi Speed Test app: Wow, it was impressive 316 Mbps (~40 MB/s). Then just downloaded and started the java version of wifi speed test app, set the IP address of the NAS and started the test: This Synology NAS already contains python support, so I could start it python wifi_speed_test_server.py So first of all, I enabled ssh connection to my NAS, then copied my wifi-speed-test-server.py file to the NAS. and the samba speed when my mobile using the NAS.the maximum available raw speed when my mobile is connected to the NAS.the maximum available raw speed when my computer is connected to the NAS. ![]() Of course you can test it via file copy but I wanted to know several values: Recently I installed a Synology NAS (DS216j) to my home and wanted to test the speed of this NAS.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |